C. Calibrate throttle travel of transmitter
Fully program ESC by Program box
Ⅳ
Page 4
Push the joystick of transmitter to max throttle position, power on the transmitter.
2nd:
ON
OFF
3rd:
4th:
After the following 2 beeps , immediately pull joystick to minimum throttle .
max throttle position (it will be 100% throttle point)
ON
OFF
ON
OFF
minimum throttle (it will be zero throttle point)
5th:
2 beeps
emitting, calibrating is finished.
-
Switch ‘OFF’ the switch;
-
Connect ESC’s receiver lead to the female housing wire (black, red and white) of
‘Y’ cables in right polarity;
-
Connect the two small wires (red and black) on ESC to the female housing wires
(black and red ) of ‘Y’ cables;
- Insert the male housing plug of ‘Y’ cables to program box in right polarity;
-
Connect ESC to battery;
-
Switch ‘ON’, the LCD panel will show the ESC’s name. It is ready to program the
ESC.
Female housing wires
(black, red, white)
Female housing wires
(black, red )
Program box
Battery
Y Cables
Male housing wires
(black, red, white)
