Ш
Using the ESC
A. ESC picture
switc
h
ON
OFF
Anti-
spark
pin
Battery wire (+)
Battery wire (
－
)
Power
LED
Receiver lead
Two small wires
*
Battery wire (+): Connect positive battery wire of ESC to positive polarity of battery pack.
*
Anti-spark pin: the pin is used to eliminate the generated sparks when connect ESC to battery.
*
Power LED: The LED is red. It lights when ESC is powered, and extinguishes when disconnect
ESC from battery.
*
Switch: The switch is used to switch on power or switch off power.
*
Red LED: When ESC is powered, if this red LED lights, it reports no radio signal is detected. It
would extinguish when radio signal is recovered.
The Red LED would flash when current limiting of ESC function.
*
Green LED: The green LED is flashing when ESC is working.
*
Two small wires: The two small wires is used
ONLY
when connect ESC to Program box.
*
Receiver lead: Plug the receiver lead to Channel 3 of receiver.
*
Battery wire (-): Connect negative battery wire of ESC to negative polarity of battery pack.
Red LED
Green LED
Page
2
