Turn of the century 20200, Руководство пользователя

Страница: 6 / 11

6
Turn of the Century
TM
ASSEMBLY INSTRUCTIONS
Black (live)
White (neutral)
Bare/Green (ground)
Black Blue White
Gree
n
7
6
5
6. Temporarily lift the motor housing up to the mounting
bracket to determine which two mounting screws in
the sides of the mounting bracket align with the L-slots
in the top edge of the motor housing. Partially loosen
the two mounting screws that align with the L-slots.
Remove the other two mounting screws from opposite
sides of the mounting bracket. Lift the motor housing
over the motor aligning the L-slots in the motor housing
with the loosened mounting screws in the mounting
bracket. Twist the motor housing clockwise to lock. Then
re-insert the two previously removed mounting screws
and tighten all four mounting screws.
7. Partially insert the blade screws along with blade
washers through the blade and into the blade arm.
Tighten blade screw with Phillips-head screwdriver,
starting with the one in the middle. Repeat this
step for the remaining blades and blade arms.
8
8. Remove the ten motor screws from the underside of
the motor. Secure the blade arm to the underneath side
of the motor using the motor screws. Completely secure
each blade arm to motor before moving to the next.
To install the fan without the light kit, skip to Step 15.
Motor Screw
Blade
Arm
Blade
Blade
Arm
Blade
Washer
Mounting
Screw
L-Slot
Motor
Housing
Blade
Screw
5. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram
and the following instructions:
• Connect the green wire from the upper bracket to the
bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note:
If there is a second hot/power wire coming from
the outlet box, connect it to the Blue (light power) fan
wire for separate light and fan control.
Important:
After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
Wire Connector
Warning:
Do NOT connect to
variable speed/dimmer-style
wall control.