Turf Tick Products Turf Tick, Оригинальное руководство пользователя

Страница: 27 / 54

26
Note 5.
The cutting knife engine drives through 3 v-belts the crankshaft from the cutting knife. The
tension of the v-belt can be changed, by sliding the frame; the cutting knife engine is mounted
to.
Note 6
A chain drives the camshaft for the chop off knife from the main roll. With the choice of two
gear wheels (parts book 100-57-30 en 100-57-32) the length at which the sod is cut off can be
changed.
The driving gear wheel
Parts book 100-57-30 The driven gear wheel
Parts book 100-57-32 Sod surface
15 teeth 55 teeth 1 m2 (sod 40 cm wide)
15 teeth 45 teeth 1 yd2 (sod 16'' wide)
17 teeth 45 teeth 1 yd2 (sod 18'' wide)
Note 7.
The tension of the chain from the camshaft drive can be adjusted by sliding the sprocket wheel
(parts book 100-57-31). Before doing the screening roof needs to be removed.
Note 8
To make sure that the chop off frame is following the crankshaft correctly, the cutting
eccentric (parts book 100-57-05) is adjustable in horizontal direction). When the machine is
delivered, this adjustment is correctly.
The right adjustment is: as far as possible in the direction of the back of the machine. Look at
the drawing below.
For the right adjustment put the camshaft as far as possible in the direction of the back
of the machine
Note: This adjustment is not meant for tightening the driving chain. This needs to be done
with the sprocket wheel (pos. nr. 7).