Turf Tick Products Turf Tick, Оригинальное руководство пользователя

Страница: 20 / 54

19
11.
If the machine is equipped with an auto steer system, put the two hydraulic tubes in the
quick couplers of the tractor.
12.
Connect the different electrical cables of the machine with the cables of the tractor.
13.
Slide bar (nr. 7) on the connection point of the tractor (nr. 9) en lock this with the lock
clip.
14.
Put the lifting chain (nr. 8) on the lifting arm (nr.10). Don’t stand in-between the
machine and the tractor, but stand on the outside of the machine.
7.3. Change cutting blade
The cutting blade of the machine is heavily loaded and for that reason in needs to be changed
regularly. The cutting blade needs to be changed if:
-
The cutting blade is that much blunt that it doesn’t cut properly any more. It starts
bending out or even pushing itself out of the ground.
- The cutting blade is unevenly worn-out, that the sod isn’t of a constant thickness
anymore. One side is thicker than the other.
Procedure changing the cutting blade:
1.
Unfold the support leg of the machine (front side of the machine). Put a support block
under the machine if it is equipped with an auto steer system.
2. Lower the machine on the support leg or support block.
3. Switch off the hydraulic – and electrical system of the machine, turn off the engine, put it
on the handbrake and get the key out of the contact.
4. Change the cutting blade. Watch out: Tighten the bolts as much as possible and remind
toothed lock washers to avoid loosening.