3. Detach the probe cable plug from the socket in the meter.
4. Remove the white nut and large O-ring.
II. Attaching a direct-insert probe
1.
If you are connecting an 8” probe, slide the white nut over the probe and
down the black cable. Skip to step 4.
2.
If you are connecting a 24” probe, remove the strain relief from the larger
plastic assembly.
3. Feed the cable and strain relief through white nut and re-connect the strain
relief and the assembly.
4. Attach the probe plug to the socket in the meter housing.
5. Push the assembly onto the meter housing so the metal pegs on the
assembly line up with the notches on the inner diameter of the meter opening.
Be sure that the small O-ring sits at the base of the large plastic assembly.
6. While holding the assembly in place hand-tighten the nut to the strain relief.
7. Connect and tighten the white nut to the meter housing.
Battery Replacement
The meter uses four AAA 1.5 V batteries.
1. To remove the battery cover, see Figure 1. Clear the front catch then the
back catch, before sliding the cover off.
2. To remove the battery plate, push the center tab towards the front of the
tester as shown in Figure 2. Once unlocked, remove the plate to access the
batteries.
3. Turn the tester upside down to remove the batteries. Each side uses two AAA
batteries. Orient each battery with positive terminal facing downward.
4. To lock the battery plate, align the small tabs (Figure 3) into the guide ribs on
the housing and then press down. See Figure 4.
