![background image](http://html1.mh-extra.com/html/turck/tbil-m1-16dxp-b/tbil-m1-16dxp-b_instructions-for-use-manual_1181727007.webp)
V01.01 | 2018/11
7
3
For Your Safety
The product is designed according to state-of-the-art technology. However, residual risks still
exist. Observe the following warnings and safety notices to prevent damage to persons and
property. Turck accepts no liability for damage caused by failure to observe these warning and
safety notices.
3.1
Intended Use
These devices are designed solely for use in industrial areas.
The block module TBIL-M1-16DXP-B is an IO-Link device (Class B) and serves as I/O hub
between field devices (sensors/actuators) and the IO-Link master. The hub has 16 I/O channels.
Each I/O channel can be used as digital in- or output without additional configuration. The
device is designed in IP67/IP69K and can be mounted directly in the field.
The devices can be used in safety functions up to Performance Level d (acc. to IEC 13849) and
SIL 2 (acc. to ISO 61508). For the outputs at the connectors C4…C7, the supply voltage V2 can
be safely switched off by an external safety relay or a safety PLC.
The devices may only be used as described in these instructions. Any other use is not in accord-
ance with the intended use. Turck accepts no liability for any resulting damage.
3.2
General Safety Instructions
n
The device may only be assembled, installed, operated, parameterized and maintained by
professionally-trained personnel.
n
The device may only be used in accordance with applicable national and international
regulations, standards and laws.
n
The device only meets the EMC requirements for industrial areas and is not suitable for use
in residential areas.
3.3
Notes on the Use in Safety-Related Applications
n
For the use in safety-related applications: Observe chapter “Using the device in safety applic-
ations”.
n
The device is part of a safety-related overall system. The overall system must always be
evaluated as a whole with regard to the requirements of EN ISO 13849-1 and EN IEC 61508.
n
The device is not specified for a certain application. Make sure that application-specific
aspects are considered.
n
Replace the device before the end of its service life (see "Safety characteristic data for the
galvanic isolation").
n
If there is a fault, e.g. a defective housing, do not use the device.
n
During operation, surface temperatures may occur that could cause burns if touched.
n
Perform a function test every 12 months
n
The devices must not be repaired. If problems occur with regard to functional safety, notify
Turck immediately and return the devices immediately to:
Hans Turck GmbH & Co. KG
Witzlebenstraße 7
45472 Muelheim an der Ruhr
Germany
Содержание TBIL-M1-16DXP-B
Страница 1: ...Your Global Automation Partner Instructions for Use TBIL M1 16DXP B I O Hub with IO Link...
Страница 2: ...2 Hans Turck GmbH Co KG T 49 208 4952 0 F 49 208 4952 264 more turck com www turck com...
Страница 32: ...Over 30 subsidiaries and over 60 representations worldwide www turck com 100003088 2018 11 100003088...