turck 100012722, Инструкция по эксплуатации

Страница: 28 / 48

Setting
Setting via touchpads
28
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
9.2.9 Parameters in the EF submenu (Extended Functions)
Explanation Options Function
MODE
Measured variable
DIST
Distance to the sensor
DPCT Distance to the sensor in % (scaled to Full-EMTY)
LVL Level
LPCT Level in % (scaled to FuLL-EMTY)
VOL Volume
VPCT Volume in % (scaled to FuLL-EMTY)
uniV Volume unit A Liter
m³ Cubic meters
in³ Cubic inch
ft³ Cubic foot
gal Gallons
uniL Unit of length mm Millimeters
m
Meters
in Inches
ft Feet
GEOM Geometry submenu For additional setting options for the container
geometry, see the Parameters in the GEOM submenu
table
Hi Maximum value memory The highest level is stored and can be displayed/
deleted (hold down [SET]).
Lo
Minimum value memory The lowest level is stored and can be displayed/
deleted (hold down [SET]).
dSP1…
dSP4 Switch delay of
SP1…SP4 0…60 s in increments of 0.1 s (0 = delay time not
active)
Default: 0.0
drP1…drP4 Switch delay of rP1…rP4 0…60 s in increments of 0.1 s (0 = delay time not
active)
Default: 0.0
dFH1…
dFH4 Switch delay of
FH1…FH4 0…60 s in increments of 0.1 s (0 = delay time not
active), only available with window mode Fno or Fnc
Default: 0.0
dFL1…dFL4 Switch delay of FL1…FL4 0…60 s in increments of 0.1 s (0 = delay time not
active), only available with window mode Fno or Fnc
Default: 0.0
dAP Damping of switching output
(filter) Filter for momentary or high frequency measurement
peaks: 0…8 s in increments of 0.01 s (0 = filter is
deactivated)
Default: 0.0
dAA Damping of analog output Filter for momentary or high frequency measurement
peaks: 0…8 s in increments of 0.01 s (0 = filter is
deactivated)
Default: 0.0
P-n Behavior of the switching output Auto Automatic detection (NPN/PNP)
NPN N switching
pnp P switching