Turbolock tl-200, Руководство пользователя

Страница: 17 / 32

TurboLock TL - 200 17
4.2 Main Installation
Step 1. Start with the outside section. Feed the power cables under the latch and
thread the latch pin and two of the pegs through the latch; the thrid and
lowest peg should be under the latch. If needed, have someone hold the door
itself or hold the outside section flat against the front of the door.
(Fig. 10)
It’s highly recommended to leave the door open and keep the keys in the lock
during installation.
Step 2. Align the plate on the back of the door while making sure to thread the cables
under the lowest peg. Move the cables to the corner opening of the plate.
Thread the latch pin through the larger hole and match up the pegs with the
smaller surrounding holes. Use the 3x mounting screws to fasten the plate to
the back of the door. Make sure all screws are tightened.
(Fig. 11)
Check and adjust the plate or cables as
needed to make sure the cables are
tucked under the lowest peg. Do NOT
force the screw through the cables as
this will damage the lock and/or make it
unusable.
2
3/4
” 2
3/8
”
Silicone Backing
2 3/4
” 2
3/8
”
2
3/4
” 2
3/8
”
2 3/4 ”
70 60
2
3/8
”
2 3/4
” 2 3/8 ”
(Fig. 10)
(Fig. 11)
Latch Pin