FGS-
1
PL1-
Mark the Door with Template
Select the height and backset as desired on the
door face; use the TEMPLATE as an indication to
mark the centre of the circle on the door face and
the centre of the door edge.
2
Backset is a distance from door edge to centr of
hole on door face.
Adjustable latch fits both backset of 2-3/8" (60 mm)
and 2-3/4" (70 mm).
e
Backset Determination
1
Drill Holes
Using the marks as a guide to drill a hole
Ø 2-1/8" (54 mm) through the door face for the lockset,
then a hole of Ø 1" (25.4 mm) for latch.
3
Install Latch
Insert the latch and ensure it is parallel to the door face.
Mark the outline of the faceplate, then take out the latch.
You need to stay this
way up when inserting
the latch.
faceplate to be aligned with the door edge.
Chisel 5/32" (4 mm) deep along the outline to allow the
Insert the latch into the door.
Use 2 wood screws to secure
latch.
Please do not fully tighten the
screws until lock is
completely installed.
Install Drive-in Latch
Drive the latch into the
hole on edge of door.
4
a
b
c
d
ELECTRONIC DEADBOLT
Installation Guide
Machine
Screws
Qty. 3
Wood Screws
Qty. 5
Deadbolt Chassis Screws
Qty. 2
J
K
L
Do not use an electric screwdriver during installation.
HARDWARE SCREWS CONTENTS
2-3/4" (70 mm)
2-3/8" (60 mm)
Determine if the latch needs to be adjusted to the2-3/4" (70 mm) backset.
To adjust, rotate the latch until it stops.
Reverse the direction to return to the 2-3/8" (60 mm) backset.
LATCH ADJUSTMENT
180°
70 mm
CHANGE LATCH FACE
Determine which latch mounting
method will be used
and
make necessary adjustments.
No adjustment required for square latch face plate.
a. Use a flat screwdriver to separate the face plate.
b. Snap selected latch face onto back plate.
Drive-in Installation
Remove original latch faceplate.
Align the
as illustrated
and snap into the latch case.
drive-in sleeve
Drive-in Latch
b
a
60 mm
PACKAGE CONTENTS
Description
Quantity
Part
A
B
C
D
Key
Cylinder
Deadbolt Keypad Assembly
Deadbolt Latch
2
1
1
1
E
F
Strike Plate
Mounting Plate
1
1
Part
Description
Quantity
G
H
Receiver Assembly
Battery Cover
1
1
I
1
Drive-in Sleeve (Optional)
B
H
J
G
L
F
E
K
D
C
A
I
