Turbolock tl-200, Руководство пользователя

Страница: 9 / 32

TurboLock TL - 200 9
Step 1.
Insert the latch into the hole and check it. The latch’s plate should sit flush against the edge of the door.
(Fig. 1)
If
there’s too much space behind the latch or if it’s sticking out of the door, the latch should be adjusted. If the latch
needs adjusting, move to Step 2. If it doesn’t need adjusting, skip to Step 3.
Step 2.
Turn the latch and extend or retract it as needed. Make sure the metal peg pops into one of the two square holes in
the side and the deadbolt is pushed all the way in while adjusting the latch’s length.
(Fig. 2)
Insert the latch back into
the door.
Step 3.
Add 2x wood screws and use a screwdriver (not included) to secure them.
(Fig. 3)
Part 2 Installing the Strike
In most cases, the existing strike plate and setup can be used. If you wish to use the one included with your lock, refer to the
instructions for Part 3 on pages 15-16.
Part 3 Adjusting for Door Orientation
Step 1.
With the door open, check it from the back and/or inside of the room. The lock’s parts should be oriented differently
depending on whether the lock will be on the left side or right side of the door.
2
3/4
” 2
3/8
”
2
3/4
” 2
3/8
”
2
3/4
” 2
3/8
”
2 3/4 ”
70 60
2 3/8 ”
2 3/4
” 2 3/8 ”
(Fig. 1)
(Fig. 2)
(Fig. 3)