Turbo Incanto T900, Инструкция по эксплуатации и обслуживанию, Страница: 9 / 36

9 GE-A18
WARNINGS
• The minimum distance between the hob and the base of the hood is 65 cm. The hob’s instruction
manual may however specify a greater distance which should be complied with instead.
• Recovered air must be channelled into a line that is used exclusively for fumes from other electrical
devices (central heating systems, thermosyphon systems, water heaters, etc.).
• Comply with air discharge regulations issued by competent authorities. Air must not be disposed of
through a cavity in the wall unless devised especially for the purpose.
• Ensure suitable ventilation when the hood is used in the same room as devices powered with energy
other than electricity (e.g. gas, oil or coal-fired burners).
The suction hood could create negative pressure in the room. This must not exceed 0.04 mbar, so as to
avoid suction of discharge gas from the heat source. You should therefore install air inlets in the room to
ensure a constant flow of fresh air!
Ensure compliance with the voltage specified on the data plate inside the device when connecting the
same to the mains. If your device is not supplied with a fitted flexible cable and plug, or with another
device enabling omnipolar disconnection from the mains, with the contacts’ opening distance of at least
3 mm, said mains disconnection devices must be used for fixed installation. If your device is equipped
with a power cable and a plug, install the device in a position where the plug is accessible.
• Always disconnect the device from the mains before any cleaning or maintenance.
USE
• Avoid use of flammable materials in proximity to the device.
• Be careful when frying with oil and grease as this can always present a risk of fire.
Used oil is especially hazardous as it is highly inflammable. Do not use exposed electric grills.
• Follow the instructions on cleaning the grease filters to avoid any potential risk of fire, and remove any
greasy deposits on the device.
MAINTENANCE
• Careful maintenance ensures good working order and durability.
• The device should be regularly cleaned of any greasy deposits, depending on how heavily it is used (at
least every 2 months). Avoid use of abrasive or corrosive products. Clean the outside of painted devices
with a cloth dampened with warm water and neutral detergent; as for cleaning the outside of steel,
copper or brass devices, use specific products mentioned in instructions on the product: use a cloth and
a brush dipped in denatured ethyl alcohol to clean inside the device.
English