Turbo Incanto T900, Инструкция по эксплуатации и обслуживанию, Страница: 6 / 36

6 GE-A18
English
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed of in the normal unsorted municipal waste stream.
Old appliances must be collected separately in order to optimise the recovery and recycling of the materials
they contain and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you
dispose of the appliance it must be separately collected. Consumers should contact their local authority or
retailer for information concerning the correct disposal of their old appliance.
Reserves the right to carry out changes without forewarning. The specifications can change from country to country.
DESCRIPTION
The hood is available in filter and suction versions.
Filter version (Fig. 1) : the hood intakes air in the kitchen impregnated with fumes and odours, and grease
and carbon filters purify the air before releasing it back into the room.
The carbon filters should be replaced periodically to ensure constant efficiency.
Suction version (Fig. 2): the hood inhales air in the kitchen impregnated with fumes and odours, passes it
through grease filters and then disposes of it via a discharge line. This version does not use carbon filters.
First decide which model you require (filter or suction version). We recommend you install the suction model
(if possible) as it offers the best performance.
INSTALLATION
We recommend you remove the metal grille or metal filters (depending on the model purchased) before
installation, as this makes the hood easier to handle.
The metal grille (Fig. 3) is removed by pushing the 2 retainer clips inwards and then turning the grille to
release it. The metal filters (Fig. 4), near the handle, are removed by pushing the retainer clip inwards and
pulling the filters downwards.
INSTALLATION OF THE SUCTION MODEL:
The air discharge line must be fitted before installation. Use a discharge pipe with the following
characteristics: - minimum essential length; - minimum number of bends (maximum angle of curve: 90°);
- type-approved material (depending on the country); - inner surface as smooth as possible. It is also
advisable to avoid pipes with marked changes in thickness (recommended diameter: 125 mm). Follow
further instructions on the “Warnings” sheet relating to air discharge.
Decide where to position the hole for air discharge: it can be in the wall or ceiling, depending on your
requirements; it must be vertical with the hob. Note that the hood can discharge air via rear opening A
(Fig.5).
Select the type of configuration best suited to your needs and fit flange C (Fig. 6) on the air discharge
opening: the 3 tabs on the flange must enter the slots on the hood; gently turn the flange clockwise until
it locks into place.
Close the other opening with the “cap” (E), following the same procedure: the 3 tabs on the cap and retainer
clip F must enter the slots on the hood; gently turn the cap clockwise until it locks into place.
Make a hole in the wall for air discharge (diameter: 133 mm), in accordance with Fig. 7 that indicates the
various possible measurements.