Continuous lighting of 3 green LED
≥
2/3
Continuous lighting of 2 green LED
≥
1/3
Continuous lighting of 1 green LED
≤
1/3
Flashing of 1 green LED
Reserve
When no LED lights up after actuating the button 14, the battery is defective and must be replaced.
For safety reasons, the charge condition of the battery can only be checked when the product is at a standstill.
During the charging procedure, the three green LED light up one after the other and briefly go out. The battery
is fully charged when the three green LED light up continuously. The three green LED lights will again light up
approximately 5 minutes after the battery has been fully charged.
Area of Cutting
(Battery Duration):
·
The area of cut (battery duration) depends on lawn conditions, grass density, moisture content, grass length
and height of cut.
·
Switching the machine on and off frequently during cutting will also reduce the area of cut (battery duration).
·
To improve the area of cut (battery duration) it is recommended to cut more frequently, raise the cutting height
and walk at a normal pace.
Charging Recommendations:
With continuous or several repetitive charging cycles without interruption, the charger will become warm to the
touch. This is not meaningful and does not indicate a technical defect of the battery charger. A significantly
reduced working period after charging indicates that the battery is used and must be replaced.
Assembly:
●
Do not connect the battery and/or the isolator key before product is completely assembled.
●
Ensure the cables are not trapped when folding/ unfolding top/bottom handles. Do not drop the
handle.
Adjusting the Cutting Height G:
●
Stop, release switch lever and wait until the motor stops before adjusting height
. The blades continue to
rotate after the machine is switched off, a rotating blade can cause serious injury.
●
Caution – do not touch the rotating blade.
For the first cutting of the season, a high cutting adjustment
