5
I. Quick Start Guide
WARNING BEFORE USE
1)
Remove the gimbal from the box.
2)
Make sure power is turned off at the back of the gimbal. The power switch is located at the back of the gimbal
on top of electronic compartment. Pressing the "0" down will power the unit off and "-" to turn it on.
3)
Charge the battery by following the instruction on Section II. Insert the battery into the tube and plug in the
battery connector. .
4)
Before setting the gimbal on the balancing stand, please follow the balancing stand setup on Section IV.
Balancing stand is an optional item and it can be purchased separately at www.turboace.com
5)
All gimbal requires balancing to establish center of gravity. When balance is not obtained, the gimbal will
vibrate during operation. When that happens, please set gimbal on the stand and follow the balancing
procedure on Section III or go to www.turboace.com for tutorial video links.
6)
Turn on the gimbal by pressing down the "-" on the power switch. Gimbal must be stationary during
initialization. Please do not allow the gimbal to swing or move it in any way. Wait for about 7 seconds and you
see the motors twitch, initialization then has been completed. You are now ready to use the gimbal.
7)
When gimbal is initialized and it is defaulted to mode #4. Please follow Section VII for detail on how each mode
functions and how they can be changed.
8)
The AllSteady-5 can be used in right side up or down configuration. Please see Section VIII for detail.
9)
Gimbal cannot be moved during initialization. Before turning on the power, please set the gimbal down on the
ground or on the balancing stand and prevent it from moving until the motors are initialized.
