Tulsa API, Инструкция по эксплуатации

Страница: 10 / 14

FSL-0019.DOCX
Page 10 of 14
Rev. 4
2.4 Parts Inspection and Replacement
Any parts found to be worn-out, broken, or have excessive wear, shall be replaced
with new parts manufactured and sold by Tulsa Winch or by a Tulsa Winch parts
distributor. All oil seals should be replaced with new seals whenever maintenance or
disassembly occurs. Care should be taken to inspect all gears, bearings, splines, and
brake clutch assembly parts.
2.5 INSPECTION RECORDS AND RECORD RETENTION
The owner as a function of conditions and usage should determine annual inspections
and maintenance of the hoist. This inspection and/or maintenance report should meet
the requirements set by API RP 2D. A copy of this report should be held at the
authorized repair facility for not less than four (4) years.
In any instance there is a question about the recommendation from Tulsa Winch, API
Specification 2C and/or API Recommended Practice 2D or other pertinent standards will
take precedence
.
3.0 Testing Brake Condition
Tulsa Winch and API RP 2D, Appendix C, C.4.1.2d, recommends that all hoists used for
personnel-handling, have their brake assemblies inspected and tested annually. A Qualified
Inspector or Qualified Operator must perform the inspection/test and document the results
for permanent record. The Qualified Inspector or Qualified Operator must test the condition
of the braking system without having to lift a load, disassemble the hoist, or adjust the
hydraulic pressure.