Mounting Extrusion - Attachment Instructions
1.
Remove the Roof Top Tent from the carton and place on a clean surface. Observe the top surface. It has four
holes in the center area of the base, then this is the side which will receive the mounting channels. Otherwise you
are looking at the surface which will receive the ladder. Open tent to gain entrance to interior and remove contents.
2.
After removing the contents, close the Roo
f
Top Tent, so the channel mounting surface is facing upward,then
move the cap of holes (side with 4 holes).
3.
Using four supplied 35mm Steel MB bolt into the mounting channels, insert it into the predrilled holes.
4.
Place mounting channels on exposed bolts
.
For side mounted orientation, ensure the mounting channels are
perpendicular
t
o hinge side. For rear moun
t
ed orientation, ensure the mounting channels are parallel to hinge side.
5.
Insert the M8 Nylock Nut with washer with 35mm steel MB bolt on the tent base. Tighten the MB Nylock Nut
using
t
he supplied 13mm wrench. Fasten mounting channels
t
o base as described above .
(Diagram
A
)
The mounting extrusion fitted to the base of the tent with the slide plate and bolt fitted.
SUMMARY:
Содержание Ranger Overland Rooftop Tent
Страница 1: ...TUFF STUFF TRAILHEAD ROOF TOP TENT...
Страница 13: ...WELCOME TO THE TRIBE...
