FIG. 10
Next, locate the
Adjustable Back Pad Tube (#11)
and insert
one Plastic Insert Cap 1 3/4 Sq. (#28) into the tube-end. Next, attach the
Adjustable Back Pad Tube (#11)
to the
Seat Pad (#12)
and secure into
place using two Hex Head Cap Screws 3/8-16 X 1 1/4 (#38) and two Flat
Washers SAE 3/8 (#46). Next, insert the
Adjustable Back Pad Tube
(#10)
into the receptacle on the
Main Frame (#1)
. Be sure to release
the Push-Pull Pin 1/2” (#25) as you begin to insert the assembled
Adjustable Back Pad Tube (#10)
into the
Main Frame (#1).
FIG. 9
Next, attach the
Right Handle (#9)
and the
Left Handle (#10)
to the
Main Frame (#1)
and secure them into place using two Hex Head
Cap Screws 3/8-16 X 3 (#42), four Flat Washers SAE 3/8 (#46) and two
Nylon Insert Jam Lock Nuts 3/8-16 (#47).
FIG. 11
Next, attach the
Seat Pad (#13)
to the
Main Frame (#1)
and
secure it into place using two Hex Head Cap Screws 3/8-16 X 1 1/4
(#38) and two Flat Washers SAE 3/8 (#46).
FIG. 12
Insert the two
Leg Pad Pivot Brackets (#17)
to, both, the
Left
Leg Arm (#2)
and the
Right
Leg Arm (#3)
. Secure them both into place
using a Retaining Snap Ring (#19), as shown in caption above. Use a
external retaining-ring pliers for this job. If this tool is not available,
carefully work each Retaining Snap Ring (#19) into the groove, then
push-up alternately with a screw driver working the Retaining Snap Ring
(#34)
into the groove of the
Leg Pad Pivot Brackets (#17)
.
Note
: Be sure to attach the
Adjustable Back Pad Tube (#11)
to the
Seat Pad (#11)
in the position as shown above.
N O T E
Note
: Be sure to position the
Right Handle (#9)
and the
Left
Handle (#10),
as pictured above.
N O T E
Note
: Be sure to position the
Seat Pad (#13)
to the
Main
Frame (#1)
as pictured above. Refer to the Exploded View
Diagram on page 7 for further clarification of this assembly.
N O T E
Note
: Be careful not to distort the Retaining Snap Rings (#19)
or bend them.
N O T E
4
AP-2TO Inner / Outer (Option)
Owner’s Manual: Assembly Instructions