FIG. 2
Next, install one Nylon Pulley 3” Rd. (#14-Labeled B) and a
Small Cover Plate (#15
), in the position shown above, to the
Main
Frame (#1)
and secure them into place using one Hex Head Cap Screw
3/8-16 X 1 1/2 (#40) and one Flat Washer SAE 3/8” (#46). Next, affix
the
Connector Tube (#8)
to the
Main Frame (#1)
, as pictured above,
and secure it into place using two Hex Head Cap Screws 3/8-16 X 2 3/4
(#41), four Flat Washers SAE 3/8” (#46) and two Nylon Insert Jam Lock
Nuts 3/8-16 (#47).
FIG. 1
Locate the
Main Frame (#1)
and, using a rubber mallet, insert
two Plastic Caps w/Groove 2 Sq. (#32) onto the tube-ends of the
Main
Frame (#1)
, as labeled above. Next, insert two Plastic Insert Caps 2” Sq.
(#30) and one Plastic Insert Cap 1 X 2 (#31) into the tube-ends of the
Main Frame (#1)
, as labeled above. Then, thread a Plastic Knob 1/2 -13
X 1 (#26) into the thread socket located on the
Main Frame (#1)
,
as pic-
tured above.
FIG. 3
Locate the
Cam Support Tube (#5)
and, using a rubber mallet,
insert two Plastic Insert Caps 1 x 2 (#31) into the tube-ends, as labeled
above. Next, install one Nylon Pulley 3” Rd. (#14-Labeled A) and a
Small Cover Plate (#15)
, in the position as shown above, to the
Cam
Support Tube (#5)
and secure them into place using one Hex Head
Cap Screws 3/8-16 X 2 3/4 (#41), two Flat Washers SAE 3/8” (#46) and
one Nylon Insert Jam Lock Nut 3/8-16 (#47).
FIG. 4
Next, insert the two
Pivot Axles (#16)
into the receptacles on
the
Main Frame (#1)
. Then, insert the
Cam Support Tube (#5)
and the
Adjustable Cam (#4)
, in the position as shown above, onto the left side
Pivot Axle (#16)
.
Owner’s Manual: Assembly Instructions
Note
: It is recommended to grease the
Pivot Axles (#16)
with
multi-purpose grease prior to assembling. In addition, be sure
to position the
Cam Support Tube (#5)
and the
Adjustable
Cam (#4),
as pictured above.
N O T E
2
Note
: The black boxed letters pointing to the pulleys are used
throughout this manual as reference to the Cable Mapping
Diagram on page 5. These black boxed letters will be primarily
used for locating certain pulleys during the assembly and the
cable routing process beginning with
Fig. 16.
N O T E
Note
: Be sure to position the
Small Cover Plate (#15)
as
shown in picture above.
N O T E
AP-2TO Inner / Outer (Option)