
FIG. 6
Next, attach the
Right Leg Arm (#3)
onto the right side
Pivot
Axle (#16)
, as pictured above.
FIG. 5
Next, attach the
Left Leg Arm (#2)
onto the left side
Pivot Axle
(#16)
, as pictured above.
FIG. 7
Locate the
Pivot Axle Support Tube (#6)
and, using a rubber
mallet, insert two Plastic Insert Caps 2 Sq. (#30) into the tube-ends, as
labeled above. Next, maneuver the two
Pivot Axles (#16)
into the holes
on the bottom side of the
Pivot Axle Support Tube (#6).
Next, mount
the
Pivot Axle Support Tube (#6)
along with the two captive
Pivot Ax-
les (#16)
to the
Main Frame (#1)
and secure it into place using two Hex
Head Cap Screws 3/8-16 X 3 (#42), four Flat Washers SAE 3/8 (#46)
and two Nylon Insert Jam Lock Nuts 3/8-16 (#47). Then, secure the two
Pivot Axles (#16)
to the
Pivot Axle Support Tube (#6)
using two Set
Screws 3/8-16 X 1/2 (#45). Use the supplied Hex Key 3/16” (#58) to se-
cure the two Set Screws 3/8-16 X 1/2 (#45) into the threaded sockets on
the
Pivot Axle Support Tube (#6)
, as shown in caption above.
FIG. 8
Connect the
Left Leg Arm (#2)
and the
Right Leg Arm (#3)
by
inserting the
Pivot Actuator Plate (#7)
into the receptacles on the
Left
Leg Arm (#2)
and the
Right Leg Arm (#3)
, as shown above. Secure
this assembly using two Flat Washers SAE 3/8 (#46) and two Nylon In-
sert Lock Nuts 3/8-16 (#48), as shown in caption above.
Note
: It is recommended to grease the axles on the
Pivot
Actuator Plate (#7)
with multi-purpose grease prior to
assembling.
N O T E
3
AP-2TO Inner / Outer (Option)