BUILD INSTRUCTIONS
Tuff Birds
Super Tough Wings & Planes
The 6x2MM Carbon Strip has to be installed at
the bottom of the fuselage, towards the tail.
Measure and mark the center of the fuselage,
draw a line and install the spar vertically inside
the fuselage. Be sure to keep the fuselage on a
flat surface to avoid any twists.
11.Install servos
Mark and cut one flute on the Stab and Rudder
to make the Elevator and Rudder. Install the Stab
in the slit in the fuselage. Cut out the notch for
the rudder in the fuse and cut out . Be sure to
keep the Stab parellel with the wings and the
rudder perpendicular to the stab.
Hinge the Stabilizer and Rudder, Install the
Stabilizer and rudder as shown. Be sure to keep
the Vertifcal fin centered on the fuselage and
perpendicular to the stabilizer .
4
Ver 1.0 25 Dec 2017
TuffStar*
1500MM EPP 3 Channel Trainer Airplane
10. Hinge & install Stab & Rudder
1
9. Cut and install the spar on the fuselage
Because the way a Hot wire CNC cuts the foam
there is about a 1 MM slit in 2 places of the
fuselage. One is at the bottom of the battery bay
and one is at the center above the battery bay.
Use Hot glue to fill and glue the joints. Be sure to
lay the fuselage on a flat surface to avoid any
twists.
8. Glue the Fuselage Cuts
Fuselage Cuts
