BUILD INSTRUCTIONS
Tuff Birds
Super Tough Wings & Planes
Lightly Sand the Wing EPS Wing Panels to
smoothen the surface, so that the laminate
adheres well. Use the supplied sand paper to
lightly sand both sides of the Main wing panels
and the Polyhedral tips.
Unpack and lay out everything from the kit. Identify all
the parts . Note and mark the Left and Right Polyhedral
Wing Tips. The Main wing panels are the same for Left
and Right side, but the Wing Tips are cut so that they
are angled upwards when glued to the Mainwing
panels. In case you find anything missing, stop and
contact us before proceeding with the build.
1. Layout and Identify the parts.
2. Sand the EPS Wing Panels
Measure and cut the supplied adhesive backed
laminate sheet to fit. One sheet should do one
main panel and one Polyhedral tip. Peel of the
backing paper and laminate the wing . Try to avoid
any air bubbles. You may use an old plastic
credit/debit card to squeeze out any bubbles. Trim
the excess laminate from the sides when done.
3. Laminate the EPS Wing Panels
The polyhedral Wing Tips need to be Glued to
the main Panel. Each Wing tip has one side that
is cut at an angle. Use a bead of hot glue to glue
the tips to the main wings. Try to keep the height
the tips the same for both wings.
4. Glue the EPS Wing Tips
2
Ver 1.0 25 Dec 2017
TuffStar*
1500MM EPP 3 Channel Trainer Airplane
Wing Tips
Wing Tips
Wing Panel
