Tucker ZAP THE BUTLER, Руководство по установке

Страница: 3 / 17

1. READ AND FOLLOW ALL INSTALLATION GUIDE INSTRUCTIONS.
2.
Install only on a properly balanced
*
garage door. An improperly balanced door has the potential to inflict severe injury.
Have a qualified service person make repairs to cables, spring assemblies and other hardware before installing the opener.
3.
Remove all ropes and remove or make inoperative all locks connected to the garage door before installing the opener.
4.
Where possible install the door opener 7 feet or more above the floor. Mount the emergency release to 3 feet above
the floor.
5. Do not connect the opener to the source of power until instructed to do so.
6. Locate the control button:
a. Within sight of the door.
b. At a minimum height of 5 feet so small children are not able to reach it.
c. Away from all moving parts of the door.
7.
Install the Entrapment Warning Label next to the control button in a prominent location. Install the Emergency Release
Marking. Attach the marking on or next to the emergency release.
8.
After installing the opener, the door must reverse when it contacts a 1.5 inch high object (or a 2” by 4” board laid flat) on
the floor.
9. SAVE THESE INSTALLATION GUIDE INSTRUCTIONS
INSTALLATION GUIDE 920.1037.03 | 03
IMPORTANT SAFETY INSTRUCTIONS WARNING TO
REDUCE THE RISK OF SEVERE INJURY OR DEATH:
*
WHAT IS A BALANCED DOOR:
1. Start with the door being “DOWN” (Close).
2. Put the door into manual mode.
3. Pull the door manually about 2 to 3 feet off the floor.
4. The door should “STAY” where you leave it at anywhere
from 1 Ft. from the floor or 1 Ft. from top.