Operation
46
Removing the accessory equipment
1. Activate the holding brake.
2. Turn off the engine and remove the ignition key.
3. Move all operating levers of the working hydraulics to both
sides repeatedly.
The hydraulic system is decompressed.
4. If present, shift the support legs from the accessory equipment
downwards to the ground and secure these.
5. Disconnect the hydraulic hoses from the quick-release
couplings.
6. Seal the quick-release couplings with dust caps.
7. Place the ends of the hydraulic hoses over the accessory
equipment.
8. Unlock the quick-change unit:
– Pull the locking shaft (1) on the handle outwards.
– Turn the locking shaft so that the locking pin (2) hooks
behind the locking bar (3).
9. Start the engine.
10. Release the holding brake.
000039
1
2
3
11. Operate the lift / lower control lever (1) to lower the quick-
change unit to the ground far enough so that the accessory
equipment unhooks.
000040
1
WARNING!
On uneven and loose ground, accessory equipment
can tip over and cause serious accidents.
•
Make sure that the accessory equipment is
standing firmly.
12. Ensure that path of travel behind the vehicle is free.
13. Drive the machine backwards away from the accessory
equipment.
The accessory equipment is disconnected from the machine.
