Tubeline Nitro 275RS, Инструкция оператора и каталог запасных частей

Страница: 15 / 76

Nitro 275RS - Section 2 - Operation 2-1
Section 2 - Operation
Preparation Safety
1. Never use the Nitro Manure Spreader until
you have read and completely understand
this manual and each of the safety messages
found on the safety signs on the Nitro Manure
Spreader.
2. Personal protection equipment including
safety glasses, safety shoes and gloves are
recommended during assembly, installation,
operation, adjustment, maintaining, repairing,
removal, cleaning or moving the unit. Do not
allow long hair, loose fitting clothing or jewelry
to be around equipment.
3. Clear working area of obstacles that might
be hooked or snagged, causing injury or
damage.
4. Use only in daylight or good artificial light.
5. Be sure machine is properly maintained,
adjusted and in good operating condition.
6. Ensure that all safety shielding and safety
signs are properly installed and in good
condition.
7. Never ride anywhere on the Nitro Manure
Spreader while setting up, operating or
troubleshooting problems.
8. The upright beaters on the Nitro can maim
or kill. Always check for bystanders before
engaging the PTO.
THINK SAFETY! WORK SAFELY!
Hydraulic Requirements
The Nitro Manure Spreader requires 16 GPM
hydraulic flow for optimal performance.
PTO / Horsepower Requirements
The Nitro 275 Manure Spreader requires a
minimum of 80 horsepower.
Hook-up / Unhooking
The Nitro Manure Spreader should always be
parked on a level, dry area that is free of debris
and foreign objects. Follow this procedure when
attaching:
1. Clear the area of bystanders and remove
foreign objects from the machine and working
area.
2. Make sure there is enough room to back the
tractor up to the hitch pole.
3. Start the tractor and slowly back it up to the
hitch point.
4. Stop the tractor engine, place all controls in
neutral, set park brake and remove ignition
key before dismounting.
5. Use the hitch pole jack to raise or lower the
pole to align with the drawbar.
6. Install a drawbar pin with provisions for a
mechanical retainer. Install the retainer.
7. Install a safety chain between the tractor
drawbar and the hitch pin.
8. Connect PTO driveline to tractor.
9. Connect the hydraulics. To connect, proceed
as follows:
• Use a clean cloth or paper towel to clean the
couplers on the ends of the hoses. Also clean
the area around the couplers on the tractor.
• Remove the plastic plugs from the couplers
and insert the male ends.
NOTICE
: If the direction of motion is wrong,
reverse the couplers.
10. Raise the hitch jack.
11. When unhooking from the tractor, reverse the
above procedure. NOTICE: Occasionally air
may become trapped in the hydraulic circuit,
making it necessary to “bleed” the circuit.
To perform this operation cycle the hydraulic
several times or especially on older tractors,
temporarily loosen an easily accessible hose
fitting enough to allow any trapped air to escape
while cycling the hydraulics. Retighten fitting.