Tubeline Nitro 275RS, Инструкция оператора и каталог запасных частей

Страница: 20 / 76

3-2 Section 3 - Transportation / Storage - Nitro 275RS
Travel Speed
A suggested starting speed is between 4-5 mph.
This can be adjusted to operator preference.
WARNING: Normally, the load itself blocks
manure and loose materials from being thrown
towards the front. As the load/pile gets reduced,
the rotation of the rear beaters can throw
some material forward, therefore it is strongly
recommended to lower the rear gate about 1/3
of the way down to prevent debris from being
projected towards the front.
Unplugging
The following is a recommended procedure
that may help if the manure spreader becomes
plugged or the PTO disengages:
1. Disengage the hydraulics that run the apron
chain.
2. Reverse the apron chain by flipping your
tractor hydraulic lever.
3. Engage the hydraulics to reverse the apron chain
in order to back material away from beaters.
Stop apron chain after material is backed
away from beaters or if pile doesn’t move.
WARNING:
Reversing chain under full load will
cause front aporn shaft to bend and/or break.
4. Engage the beaters. Bring beaters back up to
regular speed.
5. Follow the instructions in the Unloading
section (pg. 2-4) to start the apron chain in the
standard operation direction.
If this above procedure does not solve the
situation, closer inspection and possible manual
unplugging may be required. Make sure to stop
tractor and wait for all moving parts to stop before
servicing or unplugging:
WARNING: Stop tractor engine, place all controls
in neutral, set park brake, remove ignition key
and wait for all moving parts to stop before
servicing, adjusting, repairing or unplugging.
Storage and Cleaning
Disconnect PTO drive shaft and hydraulic
hoses before cleaning, adjusting, lubricating, or
servicing this machine.
1. The spreader must be thoroughly cleaned
for extended storage. Manure is acidic and
will damage paint and cause rusting of metal
components.
2. Allow the spreader to completely unload.
3. To clean the spreader, raise the rear gate.
WARNING: Turn off all power during cleaning
and inspection. Do not use power to move
any components or to discharge material
while cleaning or inspecting.
4. Hose off manure from the outside and inside
of the spreader. Completely clean manure
from moving mechanisms such as the beaters
and rear gate. Remove accumulation in
confined areas or pockets that trap manure.
5. Avoid directing high pressure spray directly on
bearings, seals and flow control valve.
6. Keep high pressure spray moving on painted
surfaces. Sustained spray on cracks or
scratches in paint can result in paint peeling.
7. Allow machine to dry.
8. Lower rear gate completely down before
storing spreader.
9. Inspect the spreader for loose connections,
damaged hydraulic hoses or connections
and for other damaged components. Repair if
necessary so the spreader is ready for future
operation. See Hydraulic Safety on page 4-1 .