TTF Limo-GT, Инструкции по обслуживанию

Страница: 7 / 35

Differential removal and installation part 1
1. Disassemble drive shafts
a. Remove wheels and brake drums to reveal drive shaft.
b. Unbolt the 4 M8 bolts from the back of the drum brake
anchor plate.
c. Use an axle puller set to remove the axle
2. Remove the motor
a. Perform service power disconnect and disconnect the
main battery B- from the motor controller (see safety
instruction section)
b. Open the motor cable enclosure and disconnect all
cables and connectors. Remove the motor cable
enclosure.
c. Unbolt 6 M6 hex bolts from the motor.
d. Support the motor with a garage jack and slide it from
the drive axle (to the right).
e. Installation is the reverse procedure
f. Apply grease on the spline before installing the motor
g. Torque values:
i. Motor flange M6: 14Nm
ii. Motor cable terminal: 12Nm
Rear axle and differential maintenance
7