●
Batteries are over 30kg, lifting and moving
the batteries should be done using the
dedicated Trojan lifting strap
●
Read the acid and electrical safety
instructions in this manual
Whenever one battery module needs replacing,
TTF recommends to replace all modules. One
fresh module can degrade quickly if the rest of the
pack is in poor health.
The battery pack can be replaced by lifting the
cells out the vehicle one by one. When installing
new cells, please follow the cable and module
orientation in image below.
For EUT terminal cable installation follow the next
steps:
1.
The cable needs to be installed on the
outer side of the terminal. The inner side is
smaller and suitable for the squared nut.
2.
Install the battery cable on the EUT
terminal according to the images below.
3.
Do a visual check if the surfaces of the
terminal and cable fully touch
4.
Use a torque wrench to tighten the nut on
14Nm.
5.
Apply battery terminal protection spray to
protect the terminal from oxidation and
dirt.
6.
Use the copper bus bars for charger and
controller cable connections (image)
Battery modules need to be securely fastened in
the battery tray. Make sure to use the battery hold
downs on all 18 locations. There are three types of
hold downs.
30
Lead acid module installation
Содержание Limo-GT
Страница 1: ...TTF Limo GT Service work instructions 1...
Страница 10: ...10 Electrical hardware...
Страница 26: ...BATTERIES 26...