14/14
Note: 1. The difference between bracket centers on both ends should be less than 6mm.
2. The bracket installation height is (H + 10
䌾
30mm). Do not install so that it places undue force on the
Cableveyor.
3. Cableveyor sag and bow will change slightly depending on temperature fluctuations and cable/hose
weight. This does not pose a problem in use.
*Important points in inserting cables and hoses
1) Insert cables and hoses so that lift slightly over the lock stay (arm) where articulating as shown below.
Fix both ends of the cables/hoses and ensure their length in the Cableveyor does not fluctuate after use
(operation).
2) Remove any twists or kinks from the cables/hoses and ensure they lay straight in the Cableveyor.
Note: Remove all twists/kinks from the cables/hoses, fix both ends, and ensure length in Cableveyor does not
fluctuate.
*After-installation inspection
1) Ensure there is no foreign matter on the guide rail, as it may cause the Cableveyor to meander or damage it.
2) Let it run a full stroke and ensure that the specified Cableveyor leeway length is present.
3) Ensure there is no undue tension on the cables/hoses during movement. (Refer to points above.)
10
Maintenance and Inspection
1) The Cableveyor does not need to be lubricated.
2) Sitting atop or placing heavy objects atop the Cableveyor may damage it.
3) Take precautions to ensure that foreign matter does not fall into or collect on the guide rail.
4) Ensure the Cableveyor’s return stroke is smooth, and that there is no undue tension on the cables/hoses.
5) Ensure there are no cracks in the Cableveyor or abnormal wear on its surface.
Parallelism
Note: 1
Center difference
Note: 3
Bow
Sag
Cable
Floor
Fixed End Bracket
Equipment
Note: 2
Installation height
(H + 10 – 30mm)
Moving End
Bracket
Cable
Cableveyor
Cables/Hoses
Arm
Ensure it is loose enough to lift a bit over the lock stay
Lock Stay Note: 1
Cableveyor meanders easily from rebound Direct
Note: 1
Good
Note: 1
Fixed
Fixed
