TSI Instruments DustTrak 854041, Руководство по установке

Страница: 6 / 8

–6–
17. Attach ferrite to
cable with one wrap
of the cable and
snap the ferrite
together.
18. Attach heated inlet
cable to heated inlet
control module (J4).
19. If using a Thiamis 1000 Node, route the other side of
the cable to the power input on the Thiamis node
(green connector). If you are not using the Thiamis
1000 telemetry node, this cable can remain
disconnected.
Heated Inlet Removal
1. Unscrew the top
knurled ring/collar
from the lower
mounting collar.
2. Inside the
Enclosure,
disconnect the
Heated Inlet cable
(note that the
connector has a
lock-release on it).
3. Remove the Ferrite
Clamp Assembly.
Note that the clamp
is released by
inserting and
twisting a small flat
blade screwdriver.
Also, for purposes
of re-assembly,
note that the cable
twists two times
through the Ferrite.
4. Carefully pull the
Heated Inlet
Assembly up.
5. Carefully pull the
Heated Inlet cable
and connector
through the slot in
the Mounting Ring.
Now the Heated
Inlet Assembly can
then be completely
removed.