–6–
8. Attach the inlet to the top of the impactor housing. Ensure the
O-ring included with the inlet kit is installed into the bottom of
the inlet.
NOTE
Be sure to install column retainer ring onto heated inlet
column (refer to steps 9 and 10 for visual of retainer ring).
Installing Heated Inlet (854041) into Environmental
Enclosure
1. Attach heated inlet control module to the front of
the Photometer. This can be done using the 2x
6-32 x 5/16 Socket Head Cap Screws and 2x flat
washers. Use a
7/64” ball driver.
2. Push out elastic plug and install
RH/Temp Sensor sealing gland.
Removable nut should be installed
on the inside of the enclosure.
W A R N I N G
Water gasket on gland must form a good seal with the exterior of the enclosure to ensure
a waterproof seal.
