
14
GAUI
GAUI
TAI SHIH HOBBY CORPORATION
TAI SHIH HOBBY CORPORATION
224 mm
a.M2x5
b.M2x4.6
c.M1.4x6
d.M2x8
Apply thread lock on all
screws in this section.
螺絲均需上止滑劑
1. Install tail servo and tail boom
support rods. Adjust tail servo
rod length.
2. Adjust position of servo base
(figure 1-1).
3. Adjust position of servo base
by turning around the
tail boom so that the
ball screw on the
servo horn is aligned (figure -2),
clip on the servo rod ball link.
1.Check Main rotor clam is leveled.
2.Check washout Arm is leveled
horizontally.
3.Check swash plate is leveled
horizontally.
4.Check servo horn is leveled
horizontally.
5.Check Tail servo horn and arm
are perpendicular.
1.組裝尾舵伺服機及支撐桿,
調整尾舵拉桿長度。
2.調整伺服器座位置(圖1-1)。
3.旋轉伺服機座使球頭呈同一直線
(圖1-2),扣上拉桿。
1
1.確認主旋翼夾頭水平。
2.確認剪型臂水平。
3.確認十字盤水平。
4.確認伺服機舵片水平。
5.確認尾舵伺機舵片與尾舵柄同
垂直。
2
3
4
5
5
ESC
GYRO
Receiver
a.M2x5
b.M2x4.6
5mm
b.M2x4.6
c.M1.4x6
d.M2x8
(1-2)
(1-1)
191.5 mm
尾伺服機組裝
電裝配置/機構檢查-1
Tail Servo Assembly
Electronics Setup / Check - 1
All use the 16mm thread rod
31mm
皆使用16mm之全牙螺桿
A
A
Содержание GAUI X2
Страница 2: ......
Страница 21: ......
Страница 22: ...MADE IN TAIWAN GAUI http www gaui com tw E mail gaui gaui com tw F A X 886 2 2610 5567 ...