TSC MH261T Series, Руководство пользователя

Страница: 55 / 68

50
mechanism.
Take Label

Peel function is enabled.

If peeler module is installed, please remove the label.

If there is no peeler module in front of the printer, please
switch off the printer and install it.

Check if the connector is plugging correctly.
Can’t downloading the file to
memory (FLASH / DRAM/CARD)

The space of memory is full.

Delete unused files in the memory.
Poor Print Quality

Ribbon and media is loaded incorrectly.

Dust or adhesive accumulation on the print
head.

Print density is not set properly.

Printhead element is damaged.

Ribbon and media are incompatible.

The printhead pressure is not set properly.

Reload the supply.

Clean the print head.

Clean the platen roller.

Adjust the print density and print speed.

Run printer self-test and check the print head test pattern
if there is dot missing in the pattern.

Change proper ribbon or proper label media.

Adjust the printhead pressure adjustment knob.

The release lever does not latch the printhead properly.
Missing printing on the left or right
side of label

Wrong label size setup.

Set the correct label size.
Gray line on the blank label

The print head is dirty.

The platen roller is dirty.

Clean the print head.

Clean the platen roller.

(Please refer to chapter 8)
Irregular printing

The printer is in Hex Dump mode.

The RS-232 setting is incorrect.

Turn off and on the printer to skip the dump mode.

Re-set the RS-232 setting.
Label feeding is not stable (skew)
when printing

The media guide does not touch the edge
of the media.

If the label is moving to the right side, please move the
label guide to left.

If the label is moving to the left side, please move the
label guide to right.
Skip labels when printing

Label size is not specified properly.

Check if label size is setup correctly.