TRUST 782AV LCD POWER VIDEO
17
U K
Set the Video Out option:
1.
Turn on the camera.
2.
Press the MENU button
.
3. Use
the
Up (7, fig. 5) and Down
button (8, fig. 5) to move the
selection bar.
4.
Select NTSC / PAL
option.
5.
Press enter key
to change the setting to
PAL
(for Europe).
6.
Move the selection bar to 50 / 60Hz
option.
7.
Press enter key
to change the setting to
50 Hz
(for Europe).
8.
Press the MENU button
to leave the menu options.
Connect camera to a TV:
1.
Connect one end of the AV cable to the camera into the video output located
above the USB connector.
2.
Connect the other end of the AV cable to your TV. Your TV must have an
input for video signals (yellow RCA plug). The yellow plug is for the image
signal. You will need an adapter if your TV only has a SCART plug. This can
be purchased from most TV and radio shops.
3.
Set your TV to display the video input.
4.
Turn the camera on. The camera image will now be visible on your TV.
Note:
Make sure to set this to PAL for use in Europe. Setting to the
wrong standard makes the screen fuzzy and everything will be
displayed in black and white.
Note:
The camera’s AV output is not suitable for connecting to the
aerial connection on your TV. Your TV must have a video input.
Note:
If you do not see an image and hear a loud humming sound
through the speakers, then you may have connected the image
plugs to the wrong connection. Check the connections and try
again.
10.9 Webcam
install
Note:
Before installing PC CAM mode, install MASS STORAGE
MODE first ! (see chapter 8.1)
Note:
Webcam function is not supported on a Mac!
This camera can be used as Webcam for video conferencing over the internet such
as Netmeeting. To install the webcam function:
1.
Install the drivers first as described in chapter 7.1.
2.
Connect the small connector of the USB cable to the USB port of the camera
(2, fig. 3).