TRUST 120V WIRELESS DVD & VIDEO VIEWER
5
Checking after installation
.
a. Check if transmitter(
A
) is at
AV
source and receiver(
B
) is at your
TV
.
b. Check if all connectors are well connected.
c. Check if all power are plugged.
d. Check if cables used are correct on the transmitter(A) and receiver(B).
e. Remote control extender performance depends on the IR sensor on your
AV source component as well. There are three ways to implement the
remote control extender, please find one which is most suitable. When
using IR sensor, please try with two people to find the best position to
stick the IR sensor. See Fig. 7 for example.
6 Troubleshooting
Method
1. Read the solutions given below.
2. Check for up-to-date FAQ’s and instruction
manuals on the Internet
!
Problem Cause
Possible
solution
Connectors are not well
connected.
Connect the connectors
firmly.
Power is not turned on.
Turn on the power.
Misplaced transmitter(A) and
receiver(B).
Refer on the product label at
the bottom of the product
and connect transmitter(
A
)
with
AV source component
and receiver(
B
) with
TV.
Not getting any
video or audio
signal on TV.
The AV source is not
playing.
Start playing the AV source
Channel switch is not set on
the same channel.
Set the channel switch on
transmitter(A) and
receiver(B) to the same
channel.
Signal transmitted is not
reaching receiver(B).
Adjust the transmitter(A) or
receiver(B) by rotating its
orientation until you get
better signal. Or relocate
them into a working range.
There is data transmitted on
the 2.4GHz band from a
wireless network as well.
Switch both transmitter(A)
and receiver(B) to another
channel. Or adjust wireless
network to another channel.
Certain channel does not
work properly.
Switch both transmitter(A)
and receiver(B) to another
channel.
The audio or video
signal is poor, or
interfered.
There is a microwave in the
path between the
transmitter(A) and
receiver(B).
Turn off the microwave.
4
