TRUST 120V WIRELESS DVD & VIDEO VIEWER
3 Approval
0678
-
This device meets the essential requirements and other relevant conditions of
the applicable European directives. The Declaration of Conformity (DoC) is
available at www.trust.com/13814.
-
This wireless device works at a frequency of 2.4GHz(AV) and 433.92MHz(IR
extender). It meets the essential requirements and other relevant conditions of
R&TTE Directive 1999/5/EC. It can be used in all EU countries and in
NO/CH/CZ/SK/HU/PL.
The following limitations are applicable for certain
countries: (a) only channel 2 is allowed using outside in France.
-
There may be limitations for the use of this device outside of the EU. If this
device is used outside of the EU, check whether this device meets local
regulations. Frequency: 2.4GHz, Bandwidth: 20MHz, Power: 10mW.
4
Installation
4.1 Product
layout
1
Power indication/IR window
5
Channel selection switch
2
Adjustable IR antenna
6
AV in jack
3
On/Off button
7
AV out jack
4
Power adapter jack
8
IR sensor jack
Table 1. Product layout (Refer on Fig. 1 for the specific part)
** Refer on the
product label
to identify
Transmitter
(
A
) and
Receiver
(
B
)!
** Antenna for audio and video signal is built in.
4.2 Connecting
Before you make connection:
a. Set the channel switch of the transmitter(A) and receiver(B) on the same channel!
To set up your transmitter(A)
1.
Take the SCART cable which
labelled with “TRANSMITTER(A)”
on its connector
2.
Connect the mini plug of the
cable to the AV jack at the rear
side of the unit(see Fig. 2)
3.
Connect the other end of the
cable to the SCART connector
on the
AV equipment
(see Fig. 2)
4.
Plug one end of the provided
power adapter into a wall outlet
and the other end to the
transmitter(see Fig. 4, step 1, 2)
5.
Turn on the transmitter by
pressing the power button in front
of the unit(see Fig. 4, step 3)
To set up your receiver(B)
1.
Take the SCART cable which
labelled with “RECEIVER(B)” on
its connector
2.
Connect the mini plug of the
cable to the AV jack at the rear
side of the unit(see Fig. 3)
3.
Connect the other end of the
cable to the SCART connector
on the
TV
(see Fig. 3)
4.
Plug one end of the provided
power adapter into a wall outlet
and the other end to the
receiver(see Fig. 4, step 1, 2)
5.
Turn on the receiver by pressing
the power button in front of the
unit(see Fig. 4, step 3)
2
