Truper 17271, Руководство пользователя, Страница: 26 / 32

Vara wax
lubricant
Lubrication
device
Lubrication
device
Start up
10
Cutting position
Cut traveling speed
Pipe
Sheet Corrugated sheet
“U” Shaped Frame Square pipe Angle Bar
The speed in which the discs can be pushed inside the work piece, while cutting is dependent of the hardness and
thickness or the work piece material.
To determine the right speed make so e test cuts with scrap pieces of the same material as the work piece. Take into
account the following considerations, because a bad cut wears out the disc in excess:
If the traveling speed is too slow:
• The cutting discs are only pressing the material instead of cutting it.
• The discs edges just slip away and damage the material.
If the traveling speed is too fast:
• The cut can get separated making splintered openings that are not wide enough to deviate the wood shavings and will
block the discs.
Cutting disc lubrication
Observations
To cut aluminum, copper, stainless
steel, or cast iron sheets 1/6” thick is essential to keep the
cutting discs lubricated during the cut. Do as follows:
• Insert a lubricating wax bar into the orifice in the
lubrication device.
• Turn the lubricating wax dosage measure knob one
quarter of a turn.
Before inserting the wax lubricating
bars into the device, remove the safety caps on each side.
Otherwise the lubricating bars will not work and can
damage the tool.
The double disc cutting width is approximately 3/16”
Verify you have that cutting width.
When cutting metal the discs do not produce sparks; only
hot shavings. To protect the face use a facemask on top
of safety glasses .
ENGLISH
CAUTION
WARNING