Truper 16278, Руководство пользователя

Страница: 24 / 32

8
Mounting
• With the help of another person, lift the work table (
A
) and
set it onto the joint ( B ). Fix the table with four sets of hex
screws and washers (
C
).
• Set the insert ( D ) in the center of the table with the bevel
facing down.
Work Table
• Set the motor band tension flywheel ( E ) using a 0,4”
wrench.
• Set the upper cutting guide height adjusting flywheel ( F )
0,55” wrench.
Flywheels
B
C
L
A
D
E
K
K
I
H
G
M
F
J
• The equipment is factory equipped with a general use
band. If the job requires a different band or if the band is
worn or damaged, replace it with a new one.
• Double check if the machine is OFF
and disconnected from the power supply.
Wear gloves to prevent injury.
• Loosen the fast release lever ( G ) in a clockwise
direction.
• Open both guards ( H ) to gain access to the cutting
band flywheels.
• Set the band passing it through the work table slot ( I )
and through the slot in the saw column (
J
). Make sure
the band teeth passing through the table slot are pointing
downwards and to the front.
• Adjust the band to run in the center of the two pulleys
(
K
) and make it tense tightening the flywheel (
L
).
• Tighten the fast release lever ( G ) in a counter clockwise
direction.
• To verify how the band passes, turn the upper flywheel manually. To rectify the band trip,
turn the upper flywheel depth knob (
M
) in the rear of the upper cabinet (see page 10).
• Close both cabinets.
Cutting Band
CAUTION
ENGLISH