Truper 12780, Руководство пользователя

Страница: 3 / 24

3
12780 12781 12782
5 A 8 A 11 A
98 ft 180 ft 196 ft
10,5 gal/min 15,8 gal/min 11,8 gal/min
1/2 Hp 3/4 Hp 1 Hp
60 Hz
Self-priming peripheral water pump
Code
Description
Voltage
Frequency
3450 RPM
Speed
Current
Power
Power Cord Grips used in this product: Type “Y”.
Tool Build Quality: Basic insulation
Thermal insulation on motor winding: Class F
127 V
1” -11,5 NPT
Outlet and Inlet Diameter
Total Manometric Maximum
Height Value / Maximum Height
50 minutes’ work per 20 min rest. Maximum 6 hours’ daily
18 AWG 16 AWG
Conductors
Work Cycle
Class I
Insulation
IPX4
Grade IP
26 ft
Maximum Suction Depth
Maximum Water Temperature
104 °F
Maximum Flow
BOPA-1/2 BOPA-1 BOPA-3/4
A professional electrician shall carry out the
connection to the power source following the electric diagram to
the right.
Use a separate electric circuit for the pump.
This circuit shall not have a conductor with a gauge lower to #12
and shall be protected with a 20 A time-delay fuse. Before you
connect the motor to the power line. double check the switch is
in the OFF position and the electric current is equal to the one
indicated in the motor nameplate. If the pump is operated with
lower voltage, the motor will get damaged.
All wiring, electric connections and the system
ground connection shall comply with the NORMA OFICIAL
MEXICANA NOM-001-SEDE, INSTALACIONES ELÉCTRICAS
(UTILIZACIÓN) or with the local codes and ordinances. Call a certified electrician. It is advisable the pump shall
feed with a circuit that includes a differential circuit breaker with an assigned current to higher than 30 mA
CAUTION
CAUTION
Switch
127 V~ 127 V~
Fuse
Pressure
switch
Motor
Connections
Motor
Connections
Thermal
connection
WARNING
Technical Data
Power Requirements
ENGLISH
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.