10
The pressure washer
will not start.
Pressure is not
constant.
The pressure washer
stops while running.
The fuse blows.
The pressure washer
is pulsating.
The pressure washer
stops and starts by
itself.
The pressure washer
starts but no water
comes out.
• The pressure washer is not connected.
• Defective power outlet.
• Blown fuse.
• Faulty extension cable.
• Pump is sucking air.
• Dirty, worn or stuck valves.
• Worn pump seals.
• The water supply is poor.
• Blown fuse.
• Incorrect voltage supply.
• Thermal sensor activated.
• Nozzle partially blocked.
• The fuse is of low ampere rating.
• There is air in the hose.
• Incorrect water supply.
• Nozzle partially blocked.
• Water filter blocked.
• Hose tangled.
• Pump or high-pressure gun is damaged.
• No water supply.
• Pump, hoses or fittings are frozen.
• No water supply.
• Water filter is blocked.
• Nozzle is blocked.
• Connect the pressure washer.
• Use a different power outlet.
• Replace the fuse. Turn other machines OFF.
• Replace the extension cable.
• Check hoses and fittings for leaks.
• Go to a Authorized Service Center.
• Go to a Authorized Service Center if the
problem persists.
• Increase water pressure, check for blockages, untwist hoses
completely.
• Replace the fuse.
• Switch off other machines. Check that the supply
voltage corresponds to those specified in these
instructions.
• Allow the pressure washer to cool down.
• Clean the nozzle.
• Switch to an installation with higher protection
than the pressure washer's amp draw.
• Try without using the extension cord.
Press the trigger on the high-pressure gun until the
water pressure is constant.
• Check that the water supply corresponds to the
required specifications. Avoid using long and thin
hoses minimum 1/2"
• Clean the nozzle.
• Clean the filter.
• Stretch the hose.
• Go to a Authorized Service
Center.
• Open or connect the water supply.
• Wait for the pump, hoses or fittings to thaw.
• Connect the water inlet.
• Clean the filter.
• Clean nozzle.
Problem
Possible cause
Solution
Troubleshooting
If problems persist despite performing the recommended corrective actions,
contact a Authorized Service Center.
ENGLISH
