Filter cap
M
N
M
1
9
Start Up
• Open the vacuum cleaner as shown on page 7 to verify
that the dry vacuum filter is properly installed.
• If not, install the filter in the filter cage (
M
) as shown. Then
install the motor cover in place.
• Do not vacuum or work near toxic,
flammable or explosive materials as indicated in the safety
warnings on page 5.
• For dry vacuuming do not use the foam
filter for wet vacuuming.
• At the end of the vacuuming job empty the canister
before storing the vacuum cleaner.
Dry vacuuming
• Open the vacuum cleaner as shown on page 6 to install
the foam filter for wet vacuuming.
• Turn the motor cover upside down and install the filter in
the filter cage (
M
1
) as shown in the picture. Then install the
motor cover in place.
• Do not vacuum or work near toxic,
flammable or explosive materials as indicated in the safety
warnings on page 5.
• Do not use the dry vacuum cloth filter
for vacuuming liquids.
• When vacuuming large quantities of
liquids, do not immerse the nozzle completely in the
liquid; leave a gap at the tip of the nozzle opening to allow
air flow. The machine is designed with a float valve that
stops the suction drive when the canister reaches its
maximum capacity. You will notice an increase in motor
speed. When this happens, turn the machine off, unplug
the power cord from the outlet, open the vacuum and
empty the liquid from the canister into a receptacle or
drain.
• When the vacuuming job is complete, open the drain
plug (
N
) to empty the container, clean and dry the inside.
Remove the foam filter, install the cartridge filter in its place
and close the drain plug before storing the vacuum
cleaner.
Wet vacuuming
ENGLISH
CAUTION
CAUTION
CAUTION
WARNING
WARNING
Turn the filter
cover clockwise to
secure the filter in
place. To remove
the filter, turn
counterclockwise
to remove the
filter