Accessory mounting
A
C
F
B
D
E
G
H
7
ENGLISH
To prevent accidents, confirm that the
switch is off and disconnect the plug from the power
supply.
Wear gloves whenever you change
accessories. They can become extremely hot during the
operation.
• Clean the accessories shanks and apply grease from the
included tubes before mounting them on the tool
fastener (
A
).
• The attachments are secured in the tool chuck by the
retaining lever (
B
). The position of the lever depends on
the type of shank of the fixture being used, usually slotted
or shouldered.
SLOTTED ACCESSORIES (
C
)
• Move the retention lever to the bottom of the fastener
without reaching the tool axis, as shown in the image (
D
).
• Insert the accessory into the fastener; ensure that the
attachment slot is parallel to the retention lever.
• Return the lever to its original position to lock the
attachment (
E
).
• Pull the bit to confirm that it is fully secured.
• To remove the accessory, move the lever to the tip of
the drill chuck and remove the accessory.
CAUTION
WARNING
ACCESORIES WITH SHOULDER (
F
)
• Move the retention lever towards the bottom of the
fastener until it exceeds the axis of the tool, as shown in
the image (
G
).
• Insert the accessory into the fastener.
• Return the lever toward the accesory to lock it (
H
).
• Make sure the shoulder is inside the retaining lever.
• Pull the bit to confirm that it is fully secured.
• To remove the accessory, pull the lever and remove the
accessory.
Adjustments
Operate the power tool only with the
auxiliary handle installed (
A
).
• The auxiliary handle can be rotated to any position and
tilted back and forth for safe, low-fatigue positioning.
• Turn the auxiliary handle knob (
B
) counterclockwise to
loosen the mount (
C
) and place the auxiliary handle in
the desired position.
• Then retighten the auxiliary handle knob by turning
clockwise.
• Make sure the band of the mount (
D
) is positioned in
the proper section of the housing.
Auxiliary handle
B
A
C
D
CAUTION
