............ www.truemfg.com ............
8
8
True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
A.
Before your new unit is connected to a power supply,
check the incoming voltage with a voltmeter. If
anything less than 100% of the rated voltage for
operation is noted, correct immediately.
B.
All units are equipped with a service cord, and must
be powered at proper operating voltage at all times.
Refer to cabinet data plate for this voltage.
TRUE
requires that a sole use circuit be dedicated for the
unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out
due to low voltage.
WARNING
Power supply cord ground should not be removed!
WARNING
Do not use electrical appliances inside the food storage
compartments of the appliances unless they are of the
type recommended by the manufacturer.
NOTE
To reference wiring diagram - Remove front louvered grill,
wiring diagram is positioned on the inside cabinet wall.
ELECTRICAL INSTRUCTIONS
Removal
A.
Open drawer completely. Roller clips will be in the down position. (see image 1 & 2)
B.
While holding the sides of the drawer, use your finger to rotate the clips upward. (see image 3)
C.
Lift drawer and remove from channel. (see image 4)
DRAWER REMOVAL AND INSTALLATION
Image 1
Image 3
Image 4
Rotate clip
upward.
Image 2
Installation
A.
Lower rear rollers into channel slots. (see image 1)
B.
With the roller clips in the upward position, lower front rollers into channel. (see image 2)
C.
Make sure roller clips are in the down position. (see image 3)
Image 1
Image 3
Image 2
