............ www.truemfg.com ............
True Food Service Equipment, Inc.
14
14
Installation Procedures (Pilasters):
Install slotted thumb screws into threaded holes along
the inside wall of the cabinet.
Slide pilasters into position behind the slotted screws.
Leave all of the thumb screws loose for adjustments when
installing tray slides.
It is critical to measure from the center of the square hole
on the front pilaster to the center hole of the rear pilaster.
This measurement should be 24 5/8” (see image 13). Do
the same on the opposite side of cabinet for single door.
Make sure the measurement (24 5/8”) is the same in the
center pilasters in 2 and 3 door units. Tap the tray slides
into the Pilasters with a rubber Mallet.
Angle & Rod Type shelving uses a 18 1/8” distance
between Pilasters. Universal Tray slides have a 21 1/4”
distance between Pilasters (see image 14).
After the pilasters are installed the Universal Tray, Angle
Type Tray, and Rod Style Tray Slides will slide into the
pilasters (see images 7-12). When disassembling or changing
tray slides a rubber mallet may be used to take out the
different tray slides. Gently tap on the under side of the tray
slide to loosen it from the pilaster.
PILASTER INSTALL/OPERATION CONTINUED...
Type Kit #1 (Angle Type Tray Slide)
Type Kit #2 (Rod Style Tray Slide)
Type Kit #3 (Universal Tray Slide)
24 5/8
(Critical Measurement Front to Rear Pilasters)
18 1/8”
Angle Type
&
Rod Type
21 1/4”
Universal
Tray Slide
Top view (Critical Measurement side to side)
7
13
8
10
12
11
9
14
INSTALLATION / OPERATION INSTRUCTIONS
