............ www.truemfg.com ............
True Food International Equipment, Inc.
6
6
INSTALLATION / OPERATION INSTRUCTIONS
A.
Before your new unit is connected to a power
supply, check the incoming voltage with a
voltmeter. If anything less than 100% of the
rated voltage for operation is noted, correct
immediately.
B.
All units are equipped with a service cord, and
must be powered at proper operating voltage
at all atimes. Refer to cabinet data plate for this
voltage.
TRUE
requires that a sole circuit be dedicated for
the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due to
low voltage.
WARNING
Power supply cord ground should not be removed!
ELECTRICAL INSTRUCTIONS
LEVELING
A.
Set unit in its final location. Be sure there
is adequate ventilation in your room. Under
extreme heat conditions, (100°F+, 38°C+), you
may want to install an exhaust fan.
WARNING
Warranty is void if ventilation is insufficient.
B.
Proper leveling of your TRUE cooler is critical
to operating success (for non-mobile models).
Effective condensate removal and door operation
will be effected by leveling.
C.
The cooler should be leveled inside the cabinet
front to back and side to side with a level.
D.
Ensure that the drain hose or hoses are
positioned in the pan.
E.
Free plug and cord from inside the lower rear of
the cooler (do not plug in).
F.
The unit should be placed close enough to the
electrical supply so that extension cords are
never used.
WARNING
Cabinet warranties are void if OEM power cord is tampered
with. TRUE will not warranty any units that are connected to an
extension cord.