30
6
» Y081564 - (EN - REV. 003) | JUNE 2022
BRAKE PAD REPLACEMENT
6.2.7 - Fit new washer and new spring clip
6.2.8 - Fit new adjuster cap, note tab position
6.2.7 Fit new washer (45) and then new spring clip (26) to
the pad retainer pin (44) (use only new parts) (see Fig.).
After any service work: Check the brake performance
and the system behaviour on a roller dynamometer.
Check function and effectiveness.
Bear in mind that a lower performance can appear
during the breaking-in phase of the brake pads and/or
the brake disc.
6.2.8 The adjuster cap (37) must then be replaced (use only
a new cap) having lightly greased its contact surface with
grease (available as Part No. II14525, K093430 or II32868)
(see Fig.).
Note:
The tag of the adjuster cap (37) should be positioned as
shown (see arrow). This ensures access is maintained for subse-
quent removal.
If required, fit cable guides and pad wear indicators (see
Section 6.3).
6.2.9 Re-fit wheel according to the vehicle manufacturer’s
recommendations.
6.2.5 Wind out the Adjuster (23) with shear adapter (61)
until the brake pads come into contact with the disc. Then
turn back the adjuster
three clicks
and check the running
clearance (see Section 5.2) .
6.2.6 After fitting the pad retainer (11) into the groove of
caliper (1), it must be depressed to enable the insertion of
the pad retainer pin (44) (only use new parts) (see Fig.).
6.2.6 - Fitting pad retainer and pin
1
44
11
44
26
45
37
