TRUArt Pyrography Pen, Руководство пользователя, Страница: 6 / 41

Copyright 2020 TRUArt LLC
6
Using your Pyrography Pen
1. Plug the Power Cord ( #4 ) into an electric outlet and turn on the On/Off Switch ( #2 ) on
the side to heat up - it usually takes less than a minute for the tool to become hot.
2. Set the round Voltage Adjustment Knob ( #3 ) to the desired voltage.
3. Voltage Display ( #12 ) will show currently selected voltage. Depending on the tip used,
different voltages will produce different temperatures. Make sure to use burn-test on a
piece of wood to confirm correct voltage setting.
4. If necessary, use the Voltage Fine Tuning Pot ( #13 ) to fine tune voltage regulator—with
the help of a small flat-head screwdriver—for optimal use with your mains electricity. A
typical case is when voltage is too high on the lowest setting or too low on highest.
When fine tuning, you should try to achieve 15V on lowest setting and 110V on max
setting.
5. Use the Handpiece Switch ( #11 ) to select Handpiece I or Handpiece II ( #6 ).
6. Always place the handpiece into the Handpiece Holder/s ( #10 ) so the tips do not touch
other objects when not in use.
7. Hold the handpiece as you would a large pencil.
8. Always practice a new technique on a sample piece before starting a new project.
9. The tool comes with various tips ( #9 ). Some tips are the same as they are most often
used and serve as replacements.
10. To clean the tips during use, use the wet Sponge ( #8 ). To wet the sponge, pour some
water on it making sure it is sufficiently wet but not swampy.
11. Use a pair of pliers to tighten the tips in the Tip Holders ( #7 ). If you try to tighten the tip
holder by hand, there is a chance you do not tighten it well enough and the tool will not
10. Handpiece Holder
11. Handpiece Switch
12. Voltage Display
13. Voltage Fine Tuning Pot
14. Pliers
15. Cleaning files
16. Small steel brush
17. Tweezers
1. Power supply
2. On/Off Switch
3. Voltage Adjustment Knob
4. Power Cord
5. Terminals
6. Two Handpieces
7. Tip Holders
8. Sponges
9. Wire Tips and Box for Tips