Tru-Turf R52-ELTac, Руководство пользователя

Страница: 11 / 58

TRU-TURF R52-ELT
AC
Golf Greens Roller Manual 8
Operation procedures
Operation procedures
Pre-operation checks
• Check batteries are fully charged.
• Ensure steering joystick has no looseness.
• Check that foot pedal depresses under normal foot
pressure and returns to the neutral position.
• Ensure that the draw bar locking catch mechanism is
securely locked to the main draw bar and the safety
pin is fi tted when trailing the roller.
• Check and tighten grub screws fi tted to the end
bearing lock rings on the rubber coated drive roller
bearings on each smoothing head and main support
bearing.
• Grease lightly Bearings fi tted to Drive Roller and
Smoothing Head pivot bearings. Replace plastic caps if
fi tted.
• Grease rod ends, sparingly.
• Check tire pressure for proper operating pressure
(25psi). Do not over infl ate.
Standard operation procedures
• Inspect and check that the roller is serviceable prior to
departing from workshop.
• Use a suitable towing vehicle to move roller from
green to green.
• Maximum recommended towing speed would be
equal to a motorized golf buggy. Approximately
4mph/7kph. Towing at excess speed or across rough
terrain may cause damage to the machine and trailer.
• When approaching the green do not tow the roller
onto the green to set up, put the roller on the fringe of
the green.
1. Put trailer in the up position,
2. Switch key to the on position,
3. Select direction of travel with the switch on top of
the steering joystick,
4. Depress the accelerator pedal to control the speed,
5. Start rolling and drive onto the green.
• Greens can be rolled in any direction; take care to
ensure there are no crease lines produced on the
surface.
• When starting to roll the green hold the accelerator
pedal down to a predetermined position and use
the switch fi tted to the top of the joystick to change
directions, this can be done on the fl y.
The roller will gently come to a stop under
regenerative braking and then gently take off in the
opposite direction until it reaches the chosen speed or
full speed, which is 8-10 mph.
The other method of operation is to use the
accelerator pedal to slow down to a stop, change
direction with the switch then accelerate off in the
opposite direction.
Either method is acceptable.
Keep the roller on the greens surface, it is not
necessary to roll onto the collars or fringes.
• The gentle take off and stopping is controlled
electronically, it is unlikely that spinning on the green
should occur; the electronics reduces the chance of
this occurring.