Page 3
Please read and understand this entire manual before attempting to assemble, operate or install the product.
1. MARK DOOR FOR DRILLING
3. MARKING THE JAMB HOLE LOCATION
2. DRILLING HOLES
a. Start 36” from floor. Fold and apply template (page 17)
to high edge of door.
b. Mark center hole on door face through guide on
template for 2-3/8” (60 mm) or 2-3/4” (70 mm)
backset.
a. Insert latch in hole keeping it parallel to face of door. Mark outline and remove latch.
b. Chisel 1/8” deep or until latch face is flush with door edge.
c. Insert latch and tighten screws.
Note: for drive in latch DRILL HOLE size indicated on template and PRESS latch until it is flush with door edge.
a. Drill 2-1/8” hole through door face as marked for lock
set.
b. Drill 1” hole in center of door edge for latch.
1 a
1 b
2 a
2 b
I N S T A L L A T I O N I N S T R U C T I O N S
DRILLING HOLE IN DOOR
4. INSTALL DEADBOLT STRIKE PLATE
a. Mark template from edge of jamb and locate
strike opening.
b. Drill 1” hole 1 3/16” deep in door jamb on
center line of screws.
c. Outline outside edges of strike. Chisel 1/6”
deep for strike or until flush.
d. Install strike and tighten screws (A).
3 a
3 b
3 c
4 a
4 b
4 c
4 d
UP
1st step if hole
is predrilled.
1st step
if replacing
faceplate.
Note: If your door has pre-drilled holes skip to step 3 C
Содержание 0711016
Страница 1: ...Page 1 0711016 ...
