Screw
Spring Washer
2
Washer (6x15mm)
2
Screw (6x35mm)
Apply instant type AB glue to appropriate position of the elevator and
pivot & round hinges. Insert the pivot & round hinges to the elevator.
Epoxy the elevator to the stabilizer.
Assemble the stabilizer to the fuselage through the tail joint.
Make sure hinges are
mounted in the same line.
1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep about 1mm width space between elevator
and trailing edge.
Elevator
Accessory list for the coming installation steps.
Fix the wing to fuselage with screws throught the holes
applied in the wings and fuselage.
2
2
Rod (2x300mm)
Pivot&round hinge(4.5X67mm)
6
Collar (2mm)
2
2
2
Screw (2x10mm)
Nut (2mm )
1
Main wing joiner (12x346mm)
2
Washer(2x5mm)
4
Washer(3x6mm)
Screw (3x25mm)
4
2
Clevis
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
8
2
TP Screw (2.3x12mm)
Servo tray(70x58x2mm)
6
Pivot & round hinges(4.5x67mm)
Control horn
20
16
19
18
4
17
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Mount the receiver and the battery to appropriate position
in the fuselage.
The sketch map when the engine install completion.
Install the servo of the throttle.
Trim a small slot in appropriate position for throttle using.
Fuel supply line
Fuel spray line
Air pressure line
Assembly of the fuel tank.
Fix the fuel tank to appropriate position in the fuselage
with cable tie.
Drill a smallhole in appropriate position for throttle.
cable tie
cable tie
cable tie
2
44
43
48
46
47
9
45
